| COLORS | FONTS | LOGOS | STRIPING | SYMBOLS |
| BANNERS | SAMPLES | INSTRUCTIONS | PRICES | ORDER |
SURFACE PREPARATION!All surfaces must be considered dirty and must be cleaned prior to the application of markings.
Clean the area where the markings are to be applied with a household cleaner, a non-ammonia base. We recommend an alcohol based cleaner such as denatured alcohol or equivalent. Rinse thoroughly and dry.
When applying letters to painted surfaces, paint should be an enamel base paint or high quality latex enamel. We do not recommend or guarantee applications to latex paint.TEMPERATURE REQUIREMENTS
Air and application surface temperatures must be above 40 degrees.
CENTER HINGE METHOD
1) Position legend with tacks (small pieces of masking tape). See figure 1
2) Apply masking tape vertically through center of legend. See figure 2
3) Remove tack from one end, lay legend over towards center tape hinge.
4) Pull release liner away from application tape and legend until close to hinge.
5) Cut release liner with scissors and discard.
6) Squeegee down exposed half of legend, holding the end up and allowing the squeegee to cause contact.
7) Remove the tack hinge and lay the other half over.
8) Remove the rest of the release liner and squeegee into place.
9) Remove application tape.
figure 1 figure 2 figure 3 figure 4
HORIZONTAL HINGE METHOD1) Position legend with tacks (small pieces of masking tape). See figure 1
2) Apply masking tape horizontally across top of legend. See figure 3
3) Remove both tacks.
4) Cut legend into smaller areas (vertically between letters). See figure 4
5) Starting at right (if right handed), flip one section over and release liner.
6) Wipe sign surface free of dust (which may have come from back of legend).
7) Squeegee into place using one smooth downward stroke. Repeat for balance of legend.
8) Re-squeegee using more pressure.
9) Remove application tape.
Copyrighted by James Wales Jr. ©2000-2002
